Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

This is a custom steel cyclocross frameset that was an oops. The rear triangle was welded with a standard road rear. It has been ridden for one year. We were able to dent the chainstays to fit a 30mm tire (I can fit a 32mm Tufo Elite, but is would only be good in dry conditions and has very little clearance). Seat tube measures 45.5cm C-T of collar. Top tube measures 52cm horizontal. Will include a carbon fork with aluminum steerer, seat collar, and headset. Fame is yellow with a metalic flake similiar to a bass
boat. There are a few paints chips at the drops outs and at the chain stays
where we put the slight dents. $175 plus some for shipping. Cranks, front
derailleur, and linear pull brakes can be included for an additional $75.

http://i1037.photobucket.com/albums/a455/offrhodes/1106121212.jpg

http://i1037.photobucket.com/albums/a455/offrhodes/1106121211b.jpg

Views: 243

Reply to This

Replies to This Discussion

email me at andrewguers at gmail dot com

Email sent.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2024   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service