CNC Lightweight Cable Hanger

Replies to This Discussion

Permalink Reply by TripleP on November 10, 2009 at 11:42am

What will the drop hanger be like? How far a drop?

• ▶ Reply

Permalink Reply by Damien Milazzo on November 10, 2009 at 7:05pm

I was thinking an inch.

• ▶ Reply

Permalink Reply by Anne on November 18, 2009 at 7:50am

Any thoughts of making one of these for 27.2 seatposts? Some of us on small frames would love to have a rear brake hanger stop that was higher.

• ▶ Reply

Permalink Reply by Damien Milazzo on November 20, 2009 at 12:15am

Yes there has been some thought because I cracked my canti boss off my moots. I'm a little concerned about the angle on the holder though. Would a straight up and down be acceptable for the cable guide?

• ▶ Reply

Permalink Reply by Anne on November 20, 2009 at 6:04am

for the seat post hanger:
I think it would be alright, there would be a bit of an angle / minor drag coming through. But if you did it with a threaded hole to allow using a threaded cable adjuster in it, the cable wouldn't be passing through as small an opening.

• ▶ Reply

Permalink Reply by Damien Milazzo on November 20, 2009 at 12:17am

Hey TripleP, go over to the weight weenies cyclo forum for updates. Im posting picture and stuff over there. I hate to load servers with a ton of pictures unnecessarily

• ▶ Reply

Permalink Reply by TripleP on November 20, 2009 at 7:13am

Cool. Which subject is it? I can't seem to find it in the WW CX forum...

• ▶ Reply

Permalink Reply by Anne on November 20, 2009 at 7:30am

Here
http://weightweenies.starbike.com/forum/viewtopic.php?f=4&t=650...

• ▶ Reply

Permalink Reply by Damien Milazzo on November 20, 2009 at 5:12pm

Thank you Ann for the help. Also, I will draw up the design for the clamp this evening and make a tester Tuesdayish. I am waiting on feedback from somebody who purchased a regular clamp and would like to make sure it works for him first. That should be before Tuesday. So if it's a bit later that is the reason. Thx again.

• ▶ Reply