Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

I just ordered some Empella Cantis for my Ridley and attempted to install them this afternoon. My only problem, one of the bushings is too tight to slide on the canti frame/fork post. Is this something that is common? All three other cantis slide on and off any four of my frame/fork posts easily but there is one stubborn one. I ordered these buggers from France and it is difficult to say the least to get anyone there to return my email. I have access to a milling machine if anyone can tell me the correct tolerances that the bushing should be? Any ideas? Thanks!

Views: 86

Reply to This

Replies to This Discussion

If it makes you feel any better, 2 of my bushings are so loose that I can move them almost 1mm each way by hand. 1 year old.

Anyone know if you can get replacement bushings from another company that fit the Empellas?
120 grit sand paper...... put it on the appropriate sized wooden dowel and do a little sanding on your bushing , or do you canti stud.....
Got a message from Cyclocrossworld that the bushings for Froggleggs are not available (though they do sell the springs).

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2019   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service