Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

My CX bike had a creak which became ever louder when I stood on the pedals (up hills, sprinting).

The eventual solution? Clean all dirt off the rear dropouts and skewer. Then smear grease on the skewer and also the inside and outside faces of the rear dropouts on the frame.

For now, the Principle of Silence is being observed properly and I can ride in peace.

Views: 283

Reply to This

Replies to This Discussion

Good catch. I found out the source of my creak was a frame cracked on down tube AND seat tube just above BB. Yow! 

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2024   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service