Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

Hey, new on forums but long time rider. I pretty much have been using my old Kelly cross to pull my daughter around on trail-a-bike last few years with my Steelman being my primary ride. Decided to build the Kelly into a SS and have ordered a WI Eno and some 180 cranks. I live in a very hilly area and was thinking of running a 32/16 or even an 18. I see the racers running much taller gearing but i just dont see myself getting up an 8 or 10 percent prolonged climb with a setup like that. Any advice appreciated.

Views: 196

Reply to This

Replies to This Discussion

Hey Noah, thanks for joining our gang of misfits :-D

Are you planning on cx / off-road use with this bike, or is it just for riding on the road?

All trail use. About 50/50 fire-roads and single track. Most of the trails around here are either climbs or descents - very little flat. Many of the climbs are 1500-2000 ft and I'd like to have a gear that allows me to make these. I see WI makes a double freewheel (Eno DOS) with 16/18 or 17/19 combos. Leaning that direction.

I think you're on the right track with the DOS freewheel. If you want real versatility, get the DOS Freewheel in 16/18 and pair that with a 34/32 ring setup on the front.

You'll have a good spread of a stiffer gear for fire roads and lower for singletrack while keeping the same chain length.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2022   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service