Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

So has anyone tried a q ring for cross? I run a single ring setup in campy and when just peddling I can feel a dead spot ...My question is given the active nature of cross I'm not sure if I would benefit from the dead spot removal....My brain at lactic threshold for an hour won't notice the spot but I could use any increase in speed...as we all know seconds add up in a cross race...

Thanks

Views: 295

Reply to This

Replies to This Discussion

My CX bike, jake the snake, has a 46 40 Q ring set up. Came set it this way, but I can say I like it a lot, I use the 40 exclusively for CX races, and honestly a 36 to 38 would be better on hilly courses, I run an 11-32 in back.

I like the feel of the Q rings and under 115 rpm cadence they feel great! My road bike has standard rings and I don't notice much difference switching bikes. You might borrow if possible or get a used one on eBay.

I will also say that the wear on the rings in 3 years that I have owned them is virtually zero. They are really well made. I'd estimate that they have 6000 miles on them!

I'd save my money, I haven't seen any credible evidence that non-round chainrings increase either power or endurance.

I certainly would not have spent the $200 plus to purchase the Q-rings, as they came with my bike used, and I might conclude that they could have contributed in part to a couple dropped chains over the years. But maybe not? Again hard to say conclusively as dropped chains have been on remounts...

I have been back and forth with Q Rings over the last couple years. Road, mtn and CX. And in the end after riding with and without them, I use them exclusively. They wear almost like iron, and I love the Q feel. I like a higher rpm as I get older and it seems to help whip around the circle, begging me to shift up another cog and keep cranking. My CX set up is single in front with a chain keeper on inside and light guide ring on the outside. Never lost a chain this way, and if I did in a crash I could just pick up the chain and drop it back on the ring. A closed top system like Pauls guide would not be good idea as the ring is changing height and adjustment would never be correct. I use a 36t front with SRAM 12-27 CX cogset in rear. Standard Force rear derailer.

As a side note, in the day before clutch derailers on mtb, I dropped the chain more than I wanted. But ever since the Type 2 was released, chain drops are not an issue. I did drop it 1x in August and that was as much low gear limit screw as wobbly rings fault.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2024   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service