i'm in the market for a new compressor. the primary use will be to seat tubeless tires as well as using it to remove grit/sand/dirt from components etc.
what you got???
thanks in advance.
josh
Tags:
I have one of these -- super lightweight and will take care of inflating just about anything short of a semi truck tire.
http://www.amazon.com/Campbell-Hausfeld-FP2028-Compressor-Accessory...
I also have one of these that I use for powering nail guns, etc.
http://www.amazon.com/PORTER-CABLE-PCFP02003-3-5-Gallon-Pancake-Com...
The little Campbell Hausfeld will do everything you want, is very light and very small, and inexpensive.
Talking of... I have a shop compressor in the garage and a 5 gal air tank and was thinking of bringing it to races since my generator is too large to fit in the car. 5 gal @ 150psi should be enough for a few tire changes I would think. I guess I should try it.
I do have a small 12VDC compressor too but it's pretty slow but would re-inflate the 5 gal tank (and thus be good enough volume-wise). I tried a 1200W inverter to power a pancake compressor once and it was not enough - the poor inverter would flip out.
Sold something in our classifieds? Find this site valuable?
Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!
Enter any amount below, and click on the cow for some good karma. Thanks!
Posted by Emma stone on March 16, 2018 at 9:00pm 0 Comments 0 Likes
Posted by Mike Macdonald on December 21, 2017 at 11:24am 0 Comments 0 Likes
Posted by R.J. Clark on November 7, 2016 at 10:43am 0 Comments 0 Likes
Posted by R.J. Clark on November 4, 2016 at 9:43am 0 Comments 0 Likes
© 2024 Created by Cyclocross Magazine. Powered by