Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

Hey guys, I'm curious on the best setup for reverse brake levers on the Ridley X Fire. What are you guys doing, especially with the rear cable routing? I'm not worried about the front, it's the rear brake and the internal cable inside the top-tube on the left side of it and I don't want the cable radius to the lever on he left to be too tight.

What has everyone else done?


Views: 414

Reply to This

Replies to This Discussion

Ok, for all of you post-watchers and Ridley riders out there who are seemingly running your brakes in the stock manner, here's what I did to switch them (it was actually quite easy).  I simply re-ran the brake lines and switched the rear derailleur and the rear brake outers that run inside the top tube, then crossed them over under the seat stay like so: 



Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!




© 2023   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service