Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

I know there is much debate about the single/double ring setups but the reason I am willing to give it a try has nothing to do with gear ratios or weight. My reason for inquiry is that whenever I pick the bike up for long amounts of time (say a staircase run-up) I always seem to trip the shift paddle (on SRAM Rival) before I remount. This is a huge hassle to have to re-shift the front derailleur every time I remount. I'm aware of all the different possibilities for single ring setups for bikes with a clamp-on derailleur and normal bottom brackets. But on a bike with a braze-on front derailleur and a BB30 bottom bracket (A Cannondale Super X in my case), what are my options in a single ring application for chain management? BTW, I would prefer not to use two chain guards.

Thanks

Views: 2367

Reply to This

Replies to This Discussion

I'd say just use an outer chainring guard and one of the K-Edge chain catchers for braze on.

I don't know about the braze-on location but, I use Pauls chain keeper/guide on both my mt bike and my cx bike. Neither one of of my bikes have braze-ons though. I tried MRP, N-Gear jump stop and some other poorly designed (it had a post and a derailler pulley) chain guide first and none were satisfactory. In my case, the Pauls has worked 99% perfectly.

A method I have done to make a cheap conversion is the chainring on the inside of the crank with a bash guard outside. Then adjust the limit screws accordingly to lock out the fr. der. My Specialized CRUX Pro is doing fine that way. Haven't dropped a chain yet. And If I want gears, switch out the gaurd for a ring, adj. the screws and viola. I am looking for function though, not weight savings.

As Patrick People Sai

I'd say just use an outer chainring guard and one of the K-Edge chain catchers for braze on.

If you want a clean setup... you can't do much more.

This is what I rigged up to allow for use of a braze-on K Edge Chain Catcher on my Trek Cronus.  Knock on wood it has worked all season.

Excellent! This is more what I was looking for. From what I can tell it looks like a seat post clamp nut on the back side of the mount (?). Can you tell me more abut the spacer between the mount and the chain catcher?

Thanks

Yep, I think the piece behind is did come from a seatpost.  The piece in front has a curved face to it.  I think it came off of a derailleur. 

Hi, thanks, I used this pic to get my setup to work as well. One additional piece of knowledge here, you can also use a cam from a quick-release as the concave cylinder, as long as that quick release is external, as in a Salsa quick release. I found one at my local for $1. This is lighter than the Seat post version (which I got from a co-op, but the threading was too big). For what its worth, its a 5mm bolt that ships with the K-Edge, and the K-Edge now comes with the needed convex piece (spacer mentioned in gdogg's post above). I took this thread on my smart phone to the bike shop, explained the idea, and they other ideas too. I have an extra convex spacer (from the co-op) if you need one gdogg.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2020   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service