Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

Hey everyone,

I'm getting ready for cross season gluing, etc, and I was wondering if anyone has had success with Stan's in Challenge tubulars. I want to use some kind of sealant so if you have had success with anything else, list those too. Thanks,

Cameron

Views: 277

Reply to This

Replies to This Discussion

I've been wondering the same thing. I tried Caffelatex this summer on my road bike with terrible results, it needs some sort of fiber or filler material to plug the holes. I was thinking of combining Stans and Caffelatex in the tubies.
Last October, I got the caffelatex for some challenge grifo tubulars and was all kinds of excited about the cool injector and the marketing about the foaming vs. static action. Then I got a flat while warming up at a big race. In desperation I injected some Stan's into a challenge grifo. It sealed almost right away, and the tire still holds air almost 1 year later. Theprosstuff.com sells a nice injector kit that minimizes the mess and has guidelines for how much to use. I now run stan's in all of my tubies as we have enough goat heads around here to want preventative sealant in tires. All the chemistry & marketing discussion caffelatex provides is impressive, but at the end of the day we want our tires to hold air when punctured and I found their product to fall short of that requirement.
My experience has been similar but not as negative as the other CaffeLatex posters. I've used stan's religiously over the past 5 years in MTB and a couple years of CX applications. This summer, I used Caffelatex for MTB and it did not seal as well. It did work, but it seemed to need to be left alone to dry up and totally seal a puncture, otherwise it would keep squirting out. When that happened on a dusty trail, it created an effective but strange looking rubber/mud glob on the outside of the tire.

Yes, CaffeLatex works, and it will be the only good sealant you can get into a tube/tubular if you have a non-removable valve core. The CaffeLatex marketing people are quick to point out the potential damage of Stan's ammonia based solutions and aluminum rims, but I have never had any problem whatsoever on any of my bikes or my wife's bikes.

Simply put, if you have a removable valve core, go with Stan's. Stan's seals faster, seals larger cuts better, Stan's wins.
Well, I think that settles it. Stan's it is. Thanks a bunch!
I have used slime with good results.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2020   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service