Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

Anyone out there tried this combination?

Not sure if setting up for the wider rim(as opposed to the 19mm standard) would affect the performance of the brake when the linear are usually intolerant to adjustments outside their design brief.

Any advice?

Views: 624

Reply to This

Replies to This Discussion

I've run the CX9s w/ Velocity A23 rims, no problems at all.  Only concession was to swap the two spacers around so that the thinner spacer was between the pad and the arm of the brake and the thicker spacer was between the arm and the nut, just the opposite of how they came out of the box.  Had to do the same thing with Avid Ultimates, BTW. 

Thanks for the advice Scott. Had to do the same with my current low profile canti's to work with major tom's.

I agree with Scott. I use CX9s with Zipp 303s (25mm width) with no problems at all.

I can confirm CX8.4s w/A23s with no problems as well. I didn't move any spacers...they are as they were straight out of the box.

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2020   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service