Cyclocross Magazine

Cyclocross Community, Forums, Classifieds, Photos and Videos

Has anyone tried running a 50 tooth on a Cannondale SuperX Rival? I have been running a road wheel set and with the 46 I run out of gears on the flats. Seeing if anyone has tried fitting one on or if it is possible with the braze-on derailleur if it would raise high enough? I know I would need a longer chain also.

Thanks in advance

Views: 162

Reply to This

Replies to This Discussion

Jeremy,

Just to make sure a simple alternative isn't an option - what's your rear cassette? If it's a 12+ you could jump to an 11, which would give you an equivalent front ring bigger than a 50 (50.6). 

I'm pretty sure you should be able to fit a 50 though...but don't have experience. Many people used to run a 48t for cx, and can't imagine the bike was designed to not accommodate that, and a 50 is barely bigger (in terms of diameter).

I do have an 11, so I will experiment with the 50 and see what happens. Thanks

RSS

Sold something in our classifieds? Find this site valuable?

Consider a donation to the cause. We're cheaper than eBay fees, and it helps us here at CXM keep the lights on!

Enter any amount below, and click on the cow for some good karma. Thanks!

Amount:



Badge

Loading…

© 2024   Created by Cyclocross Magazine.   Powered by

Badges  |  Report an Issue  |  Terms of Service